Get your bike serviced at home without any expense, the vehicle will stay in good condition and you will get great mileage

Bike Service at Home:  By servicing your bike at home, you can not only save money but also improve the performance and mileage of your bike. By following some simple steps, you can keep your bike in good condition and take good care of it. Let's know how to do bike servicing at home without any cost:

Check the oil: Check the quality of the bike's engine oil regularly. If the oil has become thick and dirty, replace it.

Oil change procedure: Start the bike for some time so that the oil warms up. Then open the oil drain nut and remove the old oil and add new oil.

Change regularly: Usually change the oil every 2,000-3,000 km. This will improve both engine performance and mileage.

2. Clean the air filter:

Cleaning the air filter: The bike's air filter can get clogged with dust and dirt, which does not provide enough air to the engine. Clean it every 2,000-3,000 km or replace it when needed.

Procedure: Remove the air filter and clean it with air or wash it with mild water and let it dry thoroughly. Then put it back.

3. Check Spark Plug:

Spark Plug Condition: Check the spark plug to make sure it is working properly. If it is damaged, replace it.

Cleaning: Remove the spark plug and clean it to ensure proper spark. Installing a new spark plug improves the bike's starting and improves fuel efficiency.

4. Check the tyre pressure:

Correct tire pressure: Check the tire pressure regularly and maintain it at the correct level. High or low pressure can affect the grip and mileage of the tire.

Rotation and alignment: Also check the condition of the tires, whether they are worn out too much or not. Check the alignment and balance of the tires before going on a long journey.

5. Adjust the brake and clutch:

Brake condition: Check the brakes regularly to make sure they are working properly. Replace brake pads or brake shoes if they are worn out.

Adjust the clutch: If the clutch feels too tight or loose, adjust it properly. This will make it easier to change gears and maintain the smoothness of the bike.

6. Chain cleaning and lubrication:

Clean the chain: Use a brush and detergent to remove dust and grease accumulated on the chain.

Lubrication: After cleaning, apply chain lube or grease on the chain so that it keeps moving properly and friction is reduced. This will reduce the pressure on the engine and improve mileage.

7. Check the battery and lights:

Battery maintenance: Clean any dirt that has accumulated on the battery terminals. If the battery is low, charge it or replace it if necessary.

Lights and indicators: Check that the headlights, taillights, and indicators are working properly. Replace faulty bulbs.

8. Check the fuel system:

Clean the fuel filter: Dirt can accumulate in the fuel filter, which can block the flow of fuel. Clean or replace it.

Cleaning the fuel tank: Make sure that there is no dirt or water accumulated inside the tank. Cleaning the tank maintains the quality of the fuel and improves mileage.